How Rough 30 Inch Bathroom Vanity

Home » Hardware » How Rough 30 Inch Bathroom Vanity

30 inch bathroom vanity – Scrub a double sink vanity is a project that requires only basic equipment and materials. Have an assistant hold two 1/2-by-24-by-48-inch boards on their long, thin edges around three meters apart. Keep these boards in parallel and consider them to be top and bottom boards. Slide a 1/2-by-24-by-36-inch table from a set of the upper and lower ends board perpendicular to them. Consider this table on a side table. Drill holes every six inches through the side table and into the top and bottom boards. Secure them in place with 2-inch wood screws drilled into each hole. Repeat for an extra side table on the opposite end.

Posted on December 16, 2016 Hardware With 0 comments

RELATED TOPIC :   Handicap Grab Bars and Disability Shower

Set a 1/2-by-36-by-49-inch board on top of the rectangular frame and adjust it so that its outside edges are even all the way around the frame. Drill holes through the board, which is the back table, each 12 inches of the top, bottom and side boards. Set a 2-inch wood screw into each hole and tighten.  Turn vanity over as the open section facing upward. Place a 1/2-by-24-by-35-inch table directly in the center of the opening 30 inch bathroom vanity, parallel to the side members. Drilling holes each six inches through the top and bottom plates and the ends of this board, which is the middle table.

12 Photos Gallery of: How Rough 30 Inch Bathroom Vanity

RELATED TOPIC :   Remove a Moen 2 Handle Shower Faucet

Attach the center board in place with 2-inch wood screws. Turn vanity, so it is in its intended orientation and repeat the central board attachment process with the rear board. Turn the unit so that the rear board is again flush with the working surface. Position two 1/2-by-24-1 / 2-by-36-inch boards, which will be on the door opening so that they are evenly lined up with the edge of the 30 inch bathroom vanity frame.